Place LED strips on the light box

Instructions for use: 5V Adhesive LED adhesive strips into a lightbox

Introduction This guide describes how to make a 5V Insert LED adhesive strips into a two-part lightbox. The Lightbox can be easily opened and closed, so installation is easy to do.

Materials required:

• 5V LED adhesive strips
• Lightbox2-part, for opening
• USB power supply or power bank
• Cleaning cloth
• Scissors (if LED strip needs to be shortened)

Step-by-step instructions

1. Preparations:

• Carefully open the lightbox by taking the two parts apart.
• Clean the inner surface on which the LED strip is to be attached with a dry or slightly damp cloth to remove dust and dirt.

2. Adjust LED strips:

• If the LED strip is too long, cut it off at a marked location (see markings on the strip).
• Make sure that the cut is made at a designated separation point so that the circuit is not interrupted.

3. Install LED strips:

• Pull off the protective film of the adhesive strip on the back of the LEDs.
• Stick the LED strip along the lightbox interior frame and press it firmly to ensure a secure hold.
• Make sure that the connection for the power supply is routed to the outside.

4. Electrical connection and test:

• Connect the USB cable of the LED strip to a power source (e.g. USB power supply or power bank).
• Turn on the LEDs and see if they light up evenly.

5. Close Lightbox:

• Reassemble the two parts of the Lightbox and make sure that the wiring is not trapped.
• Check the function again before you finally place the lightbox in its desired place.

Tips & Notes:

• Use additional adhesive dots or double-sided tape if the LED strip does not adhere strongly enough.
• If the LEDs are flickering or not glowing, check the connectors and whether the strip has been cut off correctly.

Conclusion With these simple steps, you have successfully 5V LED adhesive strips integrated into your lightbox. Have fun with the new lighting!

[product_category category=“80″]